New Balancer PCB and Kit

Noval - Octal Electrostatic Amplifier PCB and Part Kit.

ES HPA-1 PCB and Part Kit
ES HPA-1 PCB and Part Kit
Item# ES-HPA-1
Resistor Type:  JJ 12AX7S Input Tube:  JJ 12AU7/ECC802 Input Tube:  JJ 6SN7 Output Tube:  Tung Sol Reissue 6SN7GTB Output Tube:  Optional CDE 0.1uF Output Coupling Capacitors:  Assembly: 
Availability: Usually ships in 2-3 business days
This item is currently out of stock!

Product Description

ES HPA-1 PCB and Part Kit
The GlassWare Noval-Octal ES HPA-2 kit. The FR-4 PCB is lovingly and expensively made in the USA. It is extra thick, 0.094 inches (inserting and pulling tubes from their sockets won’t bend or break this board), double-sided, with plated-through heavy 2oz copper traces. The boards are 6.4 by 3.4 inches, with four mounting holes. Each PCB holds one electrostatic headphone amplifier for one channel; thus, two boards are needed for stereo use.

The circuit is relatively simple. A differential input stage (usually filled with a 12AX7) cascades into a 6SN7-based differential output stage, with a +/-300Vdc bipolar power supply. The balanced output sits near ground potential and is DC coupled to the electrostatic headphone's stators. The circuit accepts either a balanced or an unbalanced input signal. In addition, the 10uF capacitor provokes some Aikido mojo that enhances the PSRR.

With electrostatic headphones, you simply hear things that you never hear with any loudspeaker and with few other headphones; for example, classical musicians turning their sheet music over, floorboards creaking under the bass player and his fingerprints rubbing against the strings. In addition, you hear flubbed notes and clumsy recording-room edits that you never heard before. In other words, bad recordings sound bad, whereas many other headphones homogenize all recordings, smoothing over such defects, but at the cost of smearing clean recordings.

If you have never given electrostatic headphones an extended listen, you owe to yourself to do so—but please use a tube-based headphone amplifier, as most solid-state amplifier sound crazy cold and brittle in comparison.

The ES HPA-1 can be used as a power amplifier frontend, where it can drive inefficient push-pull output tubes, such as 6AS7s in a circlotron output stage or 845 output tubes in huge push-pull power amplifier. This explains why mono PCBs were made rather than a single stereo PCB. It also explains why the boards include added pads for optional output coupling capacitors.

The ES HPA-1 kit includes the PCB, four sets of hex standoffs and screws and O-rings, all the resistors and capacitors (5), and two ceramic sockets. Kit comes with user guide.

Two kits are needed for stereo. Requires a +/-300Vdc bipolar power supply, such as the PS-8.